Refer to the "Addressing Table" provided within the lab instructions to assign addresses.
Every router and switch in the topology typically requires these initial settings:
A detailed write-up for this type of Packet Tracer lab generally follows these steps: 1. Basic Device Configuration
: Use the ping command from a PC's command prompt to test connectivity to other devices. 4. Troubleshooting Checklist If connectivity fails (pings do not succeed):
: Often configured on edge routers using ip route 0.0.0.0 0.0.0.0 [Next-Hop/Exit-Interface] .
: Manually configure the IPv4 address, Subnet Mask, and Default Gateway in the Desktop > IP Configuration tab.