Kk2.jpg (2026)

: Place the flight controller (FC) on your frame with the LCD facing the front of the craft and the buttons toward the back.

: Wait for the confirmation beep (idle signal) and release the buttons. 4. Arming and Flying kk2.jpg

: Use the on-board "PI Editor" to adjust the gain settings if your drone feels shaky or sluggish. Beginners can often start with the default firmware settings provided by DroneTrest. KK2.1 Flight Controller Guide - Guides : Place the flight controller (FC) on your

: Use the "Subtrim" function on your transmitter to ensure all values (except throttle) show ZERO when the sticks are centered. 3. ESC Calibration Arming and Flying : Use the on-board "PI

: To prepare the motors for flight, move the throttle to zero and the rudder stick to the far right . A red LED or an "Armed" message on the screen will appear.

: Connect your Electronic Speed Controllers (ESCs) to the right side of the board. Ensure you use the correct motor layout for your frame type (e.g., Quadcopter X or +).

: Turn on your transmitter and set the throttle to maximum.